CARLON Cold Water Totalizing Series Turbine Meters

Have a high volume application that requires a high degree of accuracy with low maintenance features? Then Carlon has a family of meters for you. Our cold water turbine meters are available from stock in sizes 2” to 8” with larger sizes available upon request. Carlon turbine meters provide an amazing +/- 2% accuracy at flow rates from 2 GPM all the way up to 4500 GPM (8” size) and 232 psi at temperatures from 35° to 122°F. Our turbine meters are all available in totalizing and electric contact configurations so that you can run your other process equipment (Carlon valves, timers, controllers and chemical pumps) directly from our turbine meter. Carlon Turbines meet or exceed AWWA C701 specifications and can be installed horizontally, vertically, or on an incline.

Specifications

• Meter Housing: Cast Iron Epoxy Coated, inside and out.
• Pressure Rating: 7 – 232 psi.
• Temperature Range: 35° - 122°F. Protect the meter from freezing.
• PH Level Range: 6.5 – 8.0
• Accuracy: +/- 2% of maximum flow when operating between minimum and maximum flow range.
• Register Options: U.S. Gallons and Cubic Meter (Special Order)
• Specifics for EC Models only: 24v AC/DC - 10mA maximum

Installation Instructions

1. Flush the line thoroughly after all plumbing changes to prevent contaminates from entering the turbine.
2. Meter may be installed either horizontally or vertically with inlet port facing the water supply line with register facing  up in a horizontal installation.
3. There should be no mechanical stress to the meter when installing. Flange seals are not to protrude into the pipe.
4. To avoid air accumulating, install meter at the lowest possible point.

Downloads

Cold Water Turbine Datasheet

Cold Water Turbine Manual