The items listed here are NOS "New Old Stock" and are no longer available from SeaMetrics. At this time there are two complete units available. The FT415 Flow Computers will need a new Lithium Ion C Cell Battery. Retail on this package was well over $1500.00 so this is a great deal for anyone looking to replace their meter or looking for parts.
All sales are final. We guarantee the unit works and will accept returns of unused equipment within 30 days of receipt. Bench test this with a new battery before installing it or we will consider it used and cannot accept it back.
Call David Cannon with any questions before ordering.
TX100/200-SERIES Insertion Turbine Flow Sensor
FEATURES:
Wide flow range
One moving part
Hot tap available
Modular electronics compatible
Easily depth adjustable for 3-48" pipe
APPLICATIONS:
Clean water
Large pipes
Aquariums, water parks
Water & wastewater monitoring
GENERAL INFORMATION:
The TX100/200-Series are adjustable depth insertion turbines that come in brass or 316 stainless models to fit 3" to 48" pipe. Installation fittings are standard 1-1/2" (101/201) or 2" (115/215) FNPT. Fittings such as saddles and weldolets may be purchased either locally or from Seametrics.
Ruby bearings and a non-drag pickoff give these adjustable insertion turbine flow sensors a wide flow range and long life. A sensor detects the passage of miniature magnets in the rotor blades. The resulting square-wave signal can be sent for hundreds of feet without a transmitter, over unshielded cable. This signal can be connected directly to many PLC's and other controls without any additional electronics.
If desired, a modular system of electronics can be installed directly on the flow sensor or mounted remotely. The FT415 (battery powered) or FT420 (loop powered) provides digital rate and total display, as well as programmable pulse; the FT420 also provides a 4-20 mA analog output. The AO55 is a blind analog (4-20 mA) transmitter. Programmable pulse for pump pacing is available with the PD10.
The "hot-tap" models (TX115/215) can be installed or serviced without shutting down the line by means of a 2" full-port isolation valve that comes with a nipple for installation on the pipe fitting. In most circumstances, no special tool is required.
