The pump can be programmed to respond based on a selected pump condition such as tube leak, tube change, standby, repeat pulse, run, mode change, low or high signal, low or high flow, drive fault, signal overrun, transfer and off.
Features:
- Self-priming against maximum working pressure
- Can inject off-gassing solutions
- No vapor lock or loss of prime
- Simples tube replacement
- Solid one piece tube construction
- Tube lubrication not required
- Three point roller design assists with anti-siphoning
- Output reproducibility
- Output volume not affected by back pressure
- Foot, prime or de-gassing valve not required
Technical Specifications:
- Flow Rate Output Control: Varies per control mode; digital keypad
- Reproducibility: +/- 2%
- Maximum Working Pressure: 25 psi (1.7 bar), 100 psi (6.9 bar)
- Maximum Operating Temperature: 104°F (40°C)
- Maximum Suction Lift: 25 ft (7.6 m) vertical lift, based on water
- Motor Type: Brushless DC motor
- Shaft RPM (average maximum): 45
- Duty Cycle: Continuous
- Maximum Viscosity: 1500 Centipoise
- Motor Voltage (Amp Draw): 120V 60Hz 1PH (0.6); 230V 60Hz 1PH (0.3); 230V 50Hz 1PH (0.3)
- Hall Effect Max. Input Frequency: 100 KHz
- Pulse Duration Required: 10 milliseconds (minimum duration required for pump to read signal)
- Power Cord Type: 120V 60Hz SJTOWA; 230V 60Hz SJTOWA; 230V 50Hz H05RN-F
- Power Cord Plug End: 120V 60Hz 5-15P; 230V 60Hz 6-15P; 230V 50Hz CEE7/7
- Cord Length: 6 ft (1.8 m)
- Classification: Indoor/Outdoor
Materials of Construction:
- All Housings: Polycarbonate
- Pump Tube (S30, S50): Santoprene®* (FDA approved) or Versilon®**
- Pump Tube (S40): Santoprene®* (FDA approved)
- Check Valve Duckbill (S30): Santoprene®* (FDA approved) or Pellethane®†
- Ball Check Valve Components (S40, S50): Ceramic ball (FDA approved); tantalum spring; FKM seat & O-ring OR Ceramic ball (FDA approved); stainless steel spring; EPDM seat; Santoprene® O-ring
- Pump Head Rollers (S30, S40): Polyethylene
- Pump Head Rollers (S50): Polycarbonate
- Pump Head Guide Rollers (S40, S50): Polyethylene
- Suction/Discharge Line, Ferrules: Polyethylene (FDA approved)
- Tube & Injection Fittings: PVC or Polypropylene (both NSF listed)
- Connecting Nuts: PVC or Polypropylene (both NSF listed)
- 3/8″ Adapter (S30): PVC or Polypropylene (both NSF listed)
- Suction Line Strainer and Cap: PVC or Polypropylene (both NSF listed); ceramic weight
- All Fasteners: Stainless steel
- Pump Head Latches (S30): Polypropylene
- Pump Head Thumb Screws (S40, S50): Stainless steel and PVC
- Pump Head Support, Transition Sleeve (S40, S50): Santoprene®*
- Tube Pull (S40, S50): PVC
- Leak Detect Components (S30): Hastelloy®††
- Leak Detect Components (S40, S50): Hastelloy®††, stainless steel
