EX800 Series Fixed Depth Insertion Magmeter (Sensor Only)
- 1.00 LBS
- Calculated at Checkout
EX800-Series insertion electromagnetic flowmeters are designed for use with conductive liquids in 1 to 12” pipe. A choice of materials (stainless steel, brass, and PVC) allows the meter to adapt to a range of temperature, pressure, and corrosive environments.
The EX800 is highly suitable for difficult applications with changing viscosities. With no moving parts, these meters can be used in “dirty water” applications where debris would foul a mechanical meter. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough downstream to allow complete mixing of fluids before the meter).
Designed for modularity and versatility, the EX800-Series has a currentsinking pulse output that can be combined with the appropriate transmitter or indicator for the application. For basic rate/total and pulse output, the FT430 is best. For analog output and display of rate and total, the FT440 can be used. Electronic modules can be wall- or metermounted. If the EX800 meter is used with a programmable controller, the output signal can be fed direct, with no other conditioning required.
EX800-Series fixed depth insertion meters require special fittings. Factory installation in the fitting ensures correct depth placement in the pipe. The EX800-Series meter can be ordered in a full power model when a source of electricity is available, or in a low power model that can run on an external battery with solar panel.
• No moving parts
• Easy to install
• Easy to maintain
• NSF/ANSI standard (stainless only)
• Data logger (optional)
• Immersibility (optional)
• Reverse flow output (optional)
• Sensus smart output (optional with display)
• NSF/ANSI standard 61 & 372 (stainless only)