MCINJ38 Stenner Injection Check Valve Assembly With Santoprene Duckbill, 5 Pack ( High Pressure Pumps only. 26-100psi )
Use this fitting on Stenner pumps that have 3/8" OD Discharge Tubing. 3/8" Fittings are Identified by the "White" Connection Nuts.
Use this injector to successfully inject chemicals into your pipeline. This back check valve prevents backflow of water from your distribution system that could cause damage to your pump or back fill your chemical storage reservoir.
This backflow preventer has a unique step-up thread that allows you to connect it to either 1/4" or 1/2" female normal pipe thread fittings.
This fitting connects to 3/8" O.D. Tubing
Installation:
Before removing your old injector or installing a brand new one, disconnect power to pumps or motors and depressurize your system to prevent injury, damage or flooding.
Install a tee or fitting into your pipeline at the point of injection to create a 1/4" or 1/2" FNPT (female normal pipe thread) connection.
Hold your injector up to the pipe fitting as if it was installed and visually determine where the center of the pipe is so you can trim off the end of the injection quill ensuring chemical injects into the center of the water stream.
Apply a small amount of Teflon tape to the male threads then carefully tighten.
Connect you pumps discharge tubing and hand tighten connection nut.
Stenner MCCVDB0 check valve Duckbill only (Pack of 5) Upgrade your Stenner Classic Series pump effortlessly with our modular design. Replacing components has never been quicker or easier. Rest...
MCDBINJ Stenner Santoprene Check Valve, Duckbill, 1/4 inch, 5 Pack ( High Pressure Pumps only. 26-100psi ) Use this injector to successfully inject chemicals into your pipeline. This back check...
UCDBINJ Stenner Santoprene Check Valve, Duckbill, 1/4 inch, 1 Pack ( High Pressure Pumps only. 26-100psi ) Use this injector to successfully inject chemicals into your pipeline. This back check...
Check valves are the important types of injection valves used widely across the process industries. These valves are distinguished by their two openings that allow the fluid to enter and leave the...
Stenner low pressure injection fitting with 3/8" connecting nut. Fit's low pressure pumps less than 25 PSI Does not have check valve. If you need the injection check valve w/ 3/8" Connection...
Check valves are the important types of injection valves used widely across the process industries. These valves are distinguished by their two openings that allow the fluid to enter and leave the...
The Stenner Classic Series pumps are designed with a modular structure, ensuring a swift and effortless process when replacing components. These weighted strainers are authentic Stenner products,...
Ref.8, DIGITAL CIRCUIT 100÷240 Vac for TCK 803 Tekna features reduced energy consumption thanks to a Stabilized Multi Power Supply 100 - 240 Vac 50/60 Hz