Cannon Water Technology has extensive experience setting up steam boiler conductivity controller and the related boiler equipment necessary to properly feed scale and corrosion inhibitor chemicals into the steam boiler, protect steam lines from corrosion and maintain the boilers conductivity settings using skimmer blowdown controllers.
These systems consist of the following steam system components:
- Steam rated motorized ball valves with electric actuators
- Steam rated unions with orifice plate
- Steam boiler conductivity electrode
- High temperature injection quill
- High temperature corporation stop
- Steam sample cooler
Tips on steam boiler equipment installation:
When installing steam boiler equipment it's very important to follow the manufactures installation guides. Read the manual front to back before doing your installation. It will save you a lot of time and money. Cannon Water Technology is often required to work on systems that we did not have a hand in setting up. More often than not these system are installed improperly leading to inefficient systems, frequent equipment failures and costly downtime. In many cases the systems are over sized and require rework to get them to work. Size does mater. Contact us if you have any questions about setting up your skimmer blowdown controller and related equipment.
- Probes: Steam boiler electrodes should always be installed horizontally into the cross and at least 2 feet below the surface of the boilers water level. This helps to prevent the probe from being damaged by steam flashing. The probe should always be covered by water.
- Unions and Orifice Plates: These devices are very important for the prevention of steam flashing across the boiler electrode and blowdown valve. The Union should be located 5 feet or less after the boiler sensor. Always use the smallest hole that still gives you sufficient water flow. You can always drill out the hole larger if your boiler is taking too long to blowdown.